The PowerBox Cockpit SRS is identical in design and construction to the PowerBox Competition SRS, with the addition of one special feature: a freely programmable door sequencer for warbirds or jets.
Features
- SRS: Serial Receiver System provides the facility to use receivers with serial interface: Spektrum DSM2 and DSMX (incl. X-Plus channels), Multiplex M-Link, Futaba S-Bus, HoTT, JR X-BUS and Jeti R-SAT2
- Servo-Match function: servo centre, end-points and reverse for 4 channels and 8 servos
- Door sequencer: six freely programmable outputs with set-up assistant
- Unrestricted channel assignment for all PowerBox outputs
- Graphic OLED screen with 128 x 64 pixels
- Extremely user-friendly menu-based programming using the SensorSwitch
- 11+1 channels
- Signal amplification and interference suppression for all 21 outputs
- Flight recorder, recording of lost frames, fail-safe events and all battery data
- Variable frame rate, range 9ms – 21ms
- 16-bit processor for fast, high-resolution signal processing
- double-regulated output voltages for receivers and servos
- regulated voltage with selection facility, 5.9V or 7.4V
- Connection facilities for Futaba*, Jeti, Spektrum, HoTT and Multiplex MSB downlink bus systems
- Direct transmission of battery voltage and capacity to the transmitter
- Separate voltage and capacity display for each battery
- Minimum value memory alerts the user to voltage collapses
- Large-area heat-sinks for high regulator performance
- Regulator monitoring, regulator error indicator
- Support for three battery types: LiPo, NiMH / NiCd, LiFePo
- Suppression of any servo feedback currents which may occur
- Updateable with PowerBox Systems USB Interface connectors
Technical Data
- Operating voltage:4.0V - 9.0V
- Power supply:2S LiPo, 2S LiIon, 2S LiFePo, 5S NiCd/NiMH
- Current drain Power-on state:130mA
- Current drain Standby:15µA
- Maximum load current:Peak 2x20A
- Drop-out voltage:0.3V
- Output voltage:5.9V or 7.4V regulated
- Signal input:serial
- Supported RC systems:Spektrum, Futaba, HoTT, M-Link, Jeti, JR
- Receiver redundancy:SRS
- Channels:11+1
- Servo sockets:21
- Programmable servo outputs:4 channels, 8 servos
- Servo signal resolution:0.5µs
- Signal frame rate:9ms, 12ms, 15ms, 18ms, 21ms
- Screen:OLED 128 x 64 pixels, graphic
- Integral door sequencer:yes
- Supported telemetry systems:Futaba*, Jeti, Spektrum, HoTT, M-Link
- Dimensions:110 x 72 x 24 mm
- Weight:115g
- Weight Sensor Switch:15g
- Temperature range:-30°C to +75°C